- Remove the wet towels and dry the interior
- Start up the refrigerator
- Allow the refrigerator to cool down
- Return all food to the refrigerator
High temperatures can cause the inside surfaces of the refrigerator to
warp or melt. Do not use pans of HOT water,a hair dryer, or any other
high temperature devices to defrost the refrigerator. Do not use any
hard or sharp object to remove frost. Damage to refrigerator can occur.
Cleaning
A good time to clean the refrigerator is just after you defrost it.
Clean the inside of the refrigerator as often as necessary to avoid food odors:
- Remove all food from the refrigerator
Do not use abrasive cleaners, chemicals, or scouring pads because they
can damage the interior of the refrigerator.refrigerator can occur.
- Wash the interior with a mild cleaner or a solution of liquid dish detergent and warm water
- Rinse with a solution of baking soda and clean water
- Dry with a clean cloth
- Put all food back into the refrigerator
To remove and clean the drip tray:
Door Sealing
If the door does not seal correctly, excess frost will collect inside the refrigerator. Make sure the door
seals correctly:
- Close the door on a piece of paper that is about the size of a dollar
bill (See Art00980)
- Gently pull the paper
- You should feel a slight drag between the gasket and the cabinet
- Do this on all four sides of the door
- If you do not feel a slight drag on the paper, the door is not sealing
correctly
- Have your dealer or authorized Norcold Service Center correct the
seal of the door
To increase the speed of defrosting, put pans of WARM water in the
refrigerator.
- Ensure the drip tray is empty of water
- Pull the drip tray down to remove from the slots in the refrigerator cabinet
- Clean the drip tray
!
Art 00980
7
To Next Page
Loading...
