Installation Manual 3
Assemble the Enclosure
Make sure that the enclosure is the correct size:
- For N10DC models – 59.88 – 60.01 inches high x 23.50 – 23.63 inches wide x 24.00 inches deep.
Make sure the oor is solid and level:
- The oor must be metal or a wood panel and extend the full width and depth of the enclosure.
- The oor must be able to support the weight of the refrigerator and its contents.
Make sure there are no adjacent heat sources such as a furnace vent, etc.
Make sure any exterior vents are blocked.
Ventilation Requirements
This refrigerator is made for a built-in installation. Correct ventilation is necessary for the correct operation of the refrigerator
and to increase the life of the refrigerator cooling system.
Ventilation allows the natural air ow that is necessary for good refrigeration. Cooler air comes in under the refrigerator, goes
around the refrigerator coils where it removes the excess heat from the refrigerator components, and goes out through an
upper exhaust vent. If this air ow is blocked or decreased, the refrigerator will not cool correctly.
The refrigerator has a built-in vent at the top and clearance at the bottom. Make sure that the ow of air through
these vents is not blocked in any way. Blockage of air through these vents can cause:
- shortened life of the refrigerator cooling unit.
- poor cooling performance of the refrigerator.
- continuous operation of the refrigerator.
- fast battery discharge.
- void of the refrigerator warranty.
!
To Next Page
Loading...
Need help?
General
