Norcold N41X User Manual

Owner’s Manual 10
- Put a mark on the DC wires so you can put them back in the
correct location.
- Remove the DC wires from the refrigerator.5. Remove the
screws which fasten the refrigerator to the oor.
6. Remove the door from the refrigerator.
7. Remove the screws which fasten the refrigerator to the wall.
8. Remove the refrigerator from the opening.
9. Attach the door to the refrigerator.
Remove the Refrigerator
NOTE: Your dealer or an authorized Norcold Service Center
must do this procedure.
CAUTION: The rear of the refrigerator has sharp edges
and corners. To prevent cuts or abrasions when working
on the refrigerator, be careful and wear cut resistant
gloves.
1. Close the valve at the propane gas tank(s).
WARNING: To avoid possible propane gas leaks, always
use two wrenches to loosen and tighten the gas supply
line at the refrigerator’s manual shut off valve.
2. Open the lower intake vent and remove the gas supply line
from the manual shut off valve of the refrigerator.
3. Remove the AC power cord from the receptacle.
4. Remove the DC wiring from the refrigerator:
- Remove the DC wiring from the battery or the converter of
the vehicle.
WARNING: To avoid possible propane gas leaks,
always use two wrenches to loosen and tighten the gas
supply line at the refrigerator’s manual shut off valve.
- Remove the are nut from the orice assembly [77] (See
Art00956).
- Remove the orice assembly from the burner [78].
WARNING: Do not try to remove the orice [79] from
the orice adapter [80] when cleaning. Removal will
damage the orice and seal of the orice and can cause
a propane gas leak. Leaking propane gas can ignite or
explode which can result in dangerous personal injury
or death. Do not clean the orice with a pin or other
objects.
- Clean the orice assembly with air pressure and alcohol only.
- Using a wrench, assemble the orice assembly to the burner.
- Assemble the are nut to the orice assembly.
- Tighten the are nut by hand.
- Hold the orice assembly securely and, using a wrench,
tighten the are nut 1/4 revolution only.
- Examine all of the connections for gas leaks.
!
!
!
!
NOTE: Your dealer or an authorized Norcold Service Center
must do this procedure.
WARNING: Make sure the combustion seal is not
broken, is completely around the refrigerator mounting
anges, and is between the mounting anges and the wall
of the enclosure. If the combustion seal is not complete,
exhaust fumes can be present in the living area of the
vehicle. The breathing of exhaust fumes can cause
dizziness, nausea, and in extreme cases, death.
1. Push the refrigerator completely into the enclosure.
2. Remove the door from the refrigerator.
3. Put the screws though the mounting anges and into the wall.
4. Attach the door to the refrigerator
CAUTION: The rear of the refrigerator has sharp edges
and corners. To prevent cuts or abrasions when working
on the refrigerator, be careful and wear cut resistant
gloves.
5. Open the lower intake vent and put the screws through
refrigerator and into the oor.
WARNING: To avoid possible propane gas leaks, always
use two wrenches to loosen and tighten the gas supply
line at the refrigerator’s manual shut off valve.
6. Attach the gas supply line to the manual shut off valve of the
refrigerator.
7. Open the valve at the propane gas tank(s).
WARNING: Do not allow the leak checking solution
to touch the electrical components. Many liquids
are electrically conductive and can cause a shock
hazard,electrical shorts, and in some cases re.
Reinstall the Refrigerator
!
!
!
!

Norcold N41X Specifications

General

Brand	Norcold
Model	N41X
Category	Refrigerator
Language	English