Owner’s Manual 9
Refrigerator Storage
Before the refrigerator is stored for an extended (seasonal)
period of time:
- Defrost and clean the interior of the refrigerator.
- Close the doors with the storage latch.
If the refrigerator is stored for an extended period of time, before
start up:
- Make sure there are no obstructions in the vents, the
ventilation air pathway, the burner, the orice, or the ue
area.
- Make sure the burner and the burner orice are clean (See
Art00956).
- Clean if necessary.
- Make sure the electrode spark gap [167] is 1/8 - 3/16 inch
(See Art00955).
- Adjust if necessary.
- Make sure the AC voltage is 108 - 132 volts and the DC
voltage is 10.5 - 15.4 volts.
- Make sure the thermocouple tip is clean and secure.
- Make sure the area at the rear of the refrigerator is free of
any combustible materials, gasoline, and other ammable
vapors and liquids.
Refrigerator Maintenance
Gas ame appearance:
While in propane gas operation, examine the appearance of the
gas ame:
- Push and hold temperature setting button until the “9” shows
and then release.
- Open the lower intake vent.
CAUTION: The burner box cover can be hot. Wear
gloves to avoid burns.
- Open the burner box door [165] and look at the gas ame
[75] (See Art00955 and Art00975).
- The ame should be:
- a darker blue color on the inside of the ame and a
lighter blue color on the outside of the ame.
- a constant shape without ickering.
- Contact your dealer or Norcold authorized service center
if the ame is:
- yellow
- ickering or changing shape.
- Make sure the ame does not touch the inside of the
ue tube [76].
- If the ame touches the inside of the ue tube, contact
your dealer or an authorized Norcold Service Center.
- Close the burner box door.
Remove and clean the burner orice:
NOTE: Your dealer or an authorized Norcold Service Center
must do this procedure.
To remove and clean the burner orice:
- Close the valve at the propane gas tank(s).
- Close the manual shut off valve of the refrigerator.
- Shut down the refrigerator..
- Open the lower intake vent.
CAUTION: The burner box cover can be hot. Wear
gloves to avoid burns.
- Remove the burner box cover by removing one screw.