Service Manual 7
The MODE button [8] controls the operation mode of the
refrigerator.
- Push and hold the MODE button and a light bar flashes in
the center display beside each of the four operating
modes of the refrigerator, one at a time.
- There is one automatic mode of operation and three
manual modes of operation.
- When the light bar flashes beside the mode of
operation that you wish, release the MODE button.
Automatic mode operation:
When you select AUTO mode, the refrigerator controls
automatically select the most efficient energy source that is
available for operation. If a more efficient energy source
becomes available, the refrigerator controls change from the
current energy source to the more efficient energy source.
The controls select the energy source in this sequence:
- When 120 volts AC is available to the refrigerator:
- The light bars beside AUTO [3] and AC [4] show in
the center display.
- After ten seconds, the light bar beside AC goes off
and only the light bar beside AUTO remains.
- This means that the refrigerator is operating on AC
electric.
- If 120 volts AC is not available to the refrigerator:
- The light bars beside AUTO and LP GAS [6] show in
the center display.
- After ten seconds, the light bar beside LP GAS goes
off and only the light bar beside AUTO remains.
- This means that the refrigerator is operating on
propane gas.
If an energy source is available to the refrigerator, but is not
operating correctly:
- A fault code appears in the center display.
- The refrigerator controls try to change to a less efficient
energy source.
- If a less efficient energy source is not available:
- The refrigerator stops operation.
- Refer to the “Fault Codes” section of this manual.
Manual mode operation:
When you select one of the manual modes of operation, The
light bar beside the AUTO goes out in the center display and
only the light bar beside either AC, LP GAS, or DC remains.
- AC means that the refrigerator is operating on AC electric.
- LP GAS means that the refrigerator is operating on
propane gas.
If the energy source is interrupted:
- The refrigerator stops operation.
- Refer to the “Fault Codes” section of this manual.
Ignition of LP gas in either auto or manual mode:
NOTE: On initial start up of the refrigerator, ignition of the
propane gas may not occur within 30 seconds.
If ignition of the propane gas does not occur within 30
seconds:
- The gas safety valve of the refrigerator closes.
- The refrigerator stops operation.
- Refer to the “Fault Codes“ section of this manual.
- The fault code remains until you push the ON / OFF
button two times (to stop and start the refrigerator).
- If ignition does not occur after two or three times:
- Check the gas supply line.
- Refer to the “Gas Ignition Fault” chart that is in the
“Troubleshooting” section this manual.
To Next Page
Loading...
