Installation Manual 11
In Stand By Mode, the code “F” appears in the center display.
This means that the gas did not ignite.
If the gas does not ignite after several attempts, refer to the
“Fault Codes” section of this manual.
Automatic Mode Operation:
1. Push the ON/OFF button [1] to start the refrigerator.
2. Push the TEMP SET button [2] as needed to set the thermo-
stat at “4-6” temperature setting.
- If the AUTO bar [3] and AC bar [4] appear in the center
display [5], it means that:
- 120 volt AC power is available to the refrigerator.
- The refrigerator is operating on AC electric power.
- If the AUTO bar and the LP GAS bar [6] appear in the center
display, it means that:
- 120 volt AC power is not available to the refrigerator.
- The refrigerator is operating on propane gas.
Manual Mode Operation:
1. Push the ON/OFF button [1] to start the refrigerator.
2. Push the MODE button [8] until the AUTO bar goes off and
only the LP GAS bar remains.
3. Push the TEMP SET button [2] as needed, to set the thermo-
stat at “4-6” temperature setting.
4. The LP GAS bar remains until you select a different operating
mode or shut down the refrigerator.
Do a test of the gas safety valve:
1. Start up the refrigerator in the manual mode operation.
2. Open the lower intake vent.
3. Remove one wire from the solenoid of the gas safety valve at
the rear of the refrigerator.
4. Within 30 seconds, the flame should extinguish. This
means that the gas safety valve is operating correctly.
5. Put the wire back on the solenoid of the gas safety valve.
6. Close the lower intake vent.
Shut down - all models:
To shut down the refrigerator, push and hold the ON/OFF button
for two seconds.
To Next Page
Loading...
Need help?
General
