Nord Drivesystems SK 5207 - Table 12: Service and Maintenance Intervals

5 Service and maintenance
B 1050 en-1819 69
Service and Maintenance
Intervals
Service and maintenance work
Information
see Section
Every 2500 operating
hours,
but at least every six
months
• Visual inspection of shaft sealing ring
5.2.5
• Check the oil level and oil condition
5.2.6
• Clean or replace the vent
5.2.7
• Option D, ED: Visual inspection of the rubber buffers
5.2.8
• Option LC, LCX, CS1, CS2, OT: Visual inspection of hoses
and pipes
5.2.9
• Option CS1, CS2, LC, LCX: Check the oil filter
5.2.10
• Option VL2/3/4/6 KL2/3/4/6: Re-lubricate the bearings in the
output flange and remove excess grease
5.2.11
• Taconite option: Re-greasing
5.2.12
For operating temperatures
up to 80 °C:
Every 10000 operating
hours,
but at least every 2 years
Higher temperatures
reduce the oil change
intervals
• Replace shaft sealing rings if worn
5.2.5
• Oil change (the interval is double for filling with synthetic
products) reduction of the lubricant change interval for
extreme operating conditions (high humidity, aggressive
environments and large temperature fluctuations)
5.2.13
• Option CS1, CS2, LC, LCX: Replace the oil filter 5.2.10
• Option CC: Check the cooling coil for deposits (fouling)
5.2.14
Every 20000 operating
hours,
but at least every 4 years
• Re-grease the bearings in the gear unit (only for
SK5..07- SK6..07 and installation position M5/M6)
5.2.15
• Option LC, LCX, CS1, CS2, OT: Replace hose lines
5.2.9
At least every 10 years
• General overhaul
5.2.17
Table 12: Service and Maintenance Intervals
Pos: 15 2 /Allg emein/ Allg emeing ültig e Mod ule/---------Sei tenumbr uch ko mpakt --------- @ 13\mod_1476369695906_0.docx @ 2265495 @ @ 1