Nordic 3 - Program DK with Smart Remote 3 for Nrf52 Firmware; Turn on and Pair with Windows

3 Quick start
Doc. ID 4374_139 v1.1
Page 11

3.3 Program DK with Smart Remote 3 for nRF52 firmware
To use the DK add-on, the nRF52 DK must first be programmed with the firmware. The product example is
preprogrammed and does not need any programming to get started.
1. Connect the nRF52 DK with DK add-on attached to a computer with a USB cable.
2. See Firmware update of Smart Remote 3 on page 56 for details on firmware update.
3.4 Turn on and pair with Windows
The Smart Remote 3 for nRF52 can be connected to a host system with Bluetooth
®
low energy.
nRFready Smart Remote will only pair and work with Bluetooth
®
4.0 and HID over GATT compliant host
systems. The nRFready Smart Remote 3 functionality will vary depending on the supported features in these
platforms.
1. If your computer is not Bluetooth
®
4.0 hardware enabled, insert the Bluetooth
®
dongle (supplied) into your
computer and wait until the dongle is recognized and the drivers installed properly.
2. Power up the board either by inserting batteries into the battery compartment or by sliding the Power
Switch on the DK to ON position (DK add-on only).
3. Pairing mode is automatically selected if the Smart Remote 3 wasn't bound to a previous host. To delete
existing bonds and enter into pairing mode, power up the Smart Remote 3 while pressing the orange
button between Ch+ and Vol Up buttons.


4. On your computer, navigate to the Bluetooth menu (press Windows key or open the Start menu and type
Bluetooth).
