Nordic 3 - C Bus Connector; Schematics, Bill of Materials, PCB Layout Files, Production Files

5 Hardware description: Smart Remote 3 DK add-on
Doc. ID 4374_139 v1.1
Page 42
5.3.12 I
2
C bus connector
A connector for the I
2
C bus is available on the P5 header. This can be used for debugging or connecting to
external sensors.
Table 4: I
2
C bus connector pin configuration
Pin Label Description
P5_1 VCC Power supply
P5_2 GND Ground
P5_3 I2C_CLK I
2
C 1 clock
P5_4 I2C_DATA I
2
C 1 data
5.3.13 Schematics, bill of materials, PCB layout files, production files
All hardware files for the Smart Remote 3 DK add-on are available in a zip package.
The hardware files for the Smart Remote 3 DK add-on are located in the following folder in the hardware files
zip package:
\nRFready Smart Remote 3 for nRF52 series x_x_x\nRF6932 - DK Add-on x_x_x
In this folder you can find the bill of materials, schematics and PCB layout files in PDF format, Altium Designer
files, and production files (assembly drawings, gerber files, drill files, pick-and-place files).