5. Make sure that all parts are tightened before you use the treadmill. Keep the included allen wrench in a
secure place. The allen wrench is used to adjust the walking belt (see page 27). To protect the floor or carpet
from damage, place a mat under the treadmill.
7
4. Insert two Handrail Bushings (94) into the right Upright
(83). Turn the Handrail Bushings so they fit against the
Upright as shown in the inset drawing.
Insert two Handrail Bolts (96) with Handrail Washers
(95) into the Handrail Bushings (94), the right Upright
(83), and the right Handrail Spacer (92). Lift up the right
Handrail (73) and align the Bolts with the holes in the
Handrail. Next, thread the Bolts into the Handrail. Do
not tighten the Bolts yet.
Attach the left Handrail (not shown) in the same way.
Tighten all four Handrail Bolts (96).
4
96
95
94
83
73
92
94
95
To Next Page
Loading...
Need help?
General
