NordicTrack Asr 1000 Elliptical - Assembly - Rollers and Pedals; Attaching Rollers to Link Arms; Attaching Pedals

10
10. Orient a Pedal (26) as shown. Attach the Pedal
to the bracket on the Left Pedal Leg (24) with
two M8 x 55mm Patch Screws (115) and two
M8 Hex Nylon Locknuts (80).
Repeat this step to attach the other Pedal
(26).
10
25
25
77
100
27
9
9. Insert the axle of the Roller (27) through the
right Link Arm (25); make sure that the Roller
is on the inner side of the Link Arm. Attach
the Roller with an M10 x 15mm Patch Screw
(77) and an M10 x 22mm x 1.5mm Washer
(100). Tip: Use a wrench to hold the axle of
the Roller firmly in place while you tighten
the Patch Screw into the axle.
Repeat this step to attach the other Roller
(not shown) to the left Link Arm (25).
24
115
26
26
80