12
13. While a second person tips the elliptical exercis-
er forward, attach the Rear Stabilizer Cover (17)
to the Rear Stabilizer (2) with four #8 x 2"
Screws (74).
13
17
74
74
2
14. Make sure that all parts of the elliptical exerciser are properly tightened. Note: Some hardware may be
left over after assembly is completed. To protect the floor or carpet from damage, place a mat under the
elliptical exerciser.
Plug the power cord into the power socket at the front of the elliptical exerciser (see HOW TO PLUG IN THE
POWER CORD on page 13). IMPORTANT: If the elliptical exerciser has been exposed to cold tempera-
tures, allow it to warm to room temperature before plugging in the power cord. If you do not do this,
the console displays or other electronic components may become damaged.
To Next Page
Loading...
