16
HOW TO USE THE MANUAL MODE
Note: If there is a sheet of clear plastic on the face
of the console, remove the plastic.
1. Begin pedaling or press any button on the con-
sole to turn on the console.
A moment after you begin pedaling or press a but-
ton, the display will light.
2. Select the manual mode.
Each time you turn
on the console, the
manual mode will
be selected. If you
have selected a
workout, reselect
the manual mode
by pressing either of the Workouts buttons repeat-
edly until the word MANUAL appears in the lower
left corner of the display.
3. Begin pedaling and change the resistance of
the pedals and the incline of the ramp as
desired.
As you pedal,
change the resis-
tance of the ped-
als by pressing
the Resistance
increase and
decrease buttons.
Note: After you press the buttons, it will take a
moment for the pedals to reach the selected
resistance level.
To vary the motion of the pedals, you can change
the incline of the ramp. To change the incline,
press the Ramp increase and decrease buttons.
Note: After you press the buttons, it will take a
moment for the ramp to reach the selected incline
level.
4. Follow your progress with the display.
The upper left corner of the display will show
the elapsed time. Note: When a workout is select-
ed, the display will show the time remaining in the
workout instead of the elapsed time.
The lower left corner of the display will show
the distance, in total revolutions, you have ped-
aled.
The upper right corner of the display will show
the approximate number of calories you have
burned. The upper right corner of the display will
also show your heart rate when you use the hand-
grip pulse sensor (see step 5 on page 17).
The lower right corner of the display will show
your pedaling pace in revolutions per minute
(rpm).
The center of the display will show the resis-
tance level of the pedals for a few seconds each
time the resistance level changes. This display will
also show the ramp incline level for a few seconds
each time the ramp incline level changes.
You can also view selected information at a larger
size. Press the Display Mode button repeatedly to
view time and distance information, time and calo-
rie information, or time and pace information.
Press the Display Mode button again to view all
information.
To adjust the volume level of the console, press
the increase and decrease buttons located next to
the Enter button.
The console has two backlight options. The “On”
option keeps the backlight on while the console is
on. The “Off” option turns the backlight off. To
select a backlight option, first press and hold down
the Display Mode button for several seconds.
Next, press the increase button located next to the
Enter button to select the desired backlight option.
Then, press the Display Mode button to save your
selection.
To Next Page
Loading...
Need help?
General
