1.
Remove the two M10 x 120mm Patch Screws
(78) and the shipping bracket (not shown)
attached to the front of the Frame (1). Discard
the shipping bracket; do not discard the two
Patch Screws.
Orient the Front Stabilizer (49) with the Wheels
(8) in the position shown. While a second per-
son tips the Frame (1) backward, attach the
Front Stabilizer to the Frame with the two M10 x
120mm Patch Screws (78).
6
2. Identify the Right Handlebar (36), which is
marked with an “R” sticker. While a second per-
son holds the Right Handlebar near the Right
Upper Body Arm (37), connect the Right
Handlebar Wire (88) to the Right Extension Wire
(111). Insert the excess wire into the Right
Handlebar.
Attach the Right Handlebar (36) to the Right
Upper Body Arm (37) with two M6 x 18mm
Patch Screws (108) using holes (A) and (B) (see
the inset drawing). Next, attach the Upper Body
Endcap (34) to the Right Handlebar and the
Right Upper Body Arm with an M6 x 18mm
Patch Screw (108) using hole (C).
Repeat this step for the other side of the
elliptical exerciser.
78
49
1
2
1
37
8
8
108
36
34
88
111
To make assembly easier, read the
information on page 5 before you begin
assembling the elliptical exerciser.
Wire
Slot
37
B
A
C
To Next Page
Loading...
Need help?
General
