NordicTrack C1250 - Page 10

10
9. Remove and discard the four indicated Screws
(B).
B
9
B
8. Set the console assembly face down on a soft
surface to avoid scratching the console
assembly.
Remove the Screws (A) attaching the Crossbar
(
93). Note: There may be fewer Screws than
shown. Next, lift off the Crossbar (93). Then, re-
move the two screws attaching the Console
Frame (104). Discard all Screws.
93
Console
Assembly
A
8
A
A
104
10. IMPORTANT: To avoid damaging the
Crossbar (93), do not use power tools and
do not overtighten the #10 x 3/4" Screws (9).
Orient the Crossbar (93) as shown. Tighten all
four #10 x 3/4" Screws (9) about halfway into
the Handrails (87, 88). Slide the Crossbar as far
forward as possible and tighten the four Screws.
93
88
9
10
9
87