NordicTrack C1250 - Page 8

8
5. Identify the Left and Right Base Covers (82, 83).
Slide the Left Base Cover onto the Left Upright
(89). Slide the Right Base Cover onto the Right
Upright (90). Do not press the Base Covers
into place yet.
Remove the wire tie from the Upright Wire (81).
89
82
90
83
5
4. Hold the Left Upright (89) against the Base
(94). Be careful not to pinch any wires. Insert
two 3/8" x 2 3/4" Screws (7) and two 3/8" x 1
1
/4" Screws (8) with two 3/8" Star Washers (13)
into the Left Upright.
Partially tighten the 3/8" x 2 3/4" Screws (7) and
the 3/8" x 1 1/4" Screws (8) until the heads of
the Screws touch the Left Upright (89); do not
fully tighten the Screws yet.
Attach the Right Upright (not shown) in the
same way. Note: There are no wires on the
right side.
89
94
4
8
7
13
13
Wire
Tie
81