The Training Zones
display--This display
indicatestheapproxi-
mate intensitylevel of
yourexercise.Iffiveor
sixindicatorsare lit,for
example, the display
shows thatyourpace is
ideal for aerobic exercise.
7rainfrlg Zones ]
.......==]
........_=!
The Time/Distance dis-
play--This display will
show the elapsed time
and the distancethatyou
have walked or rundur-
ingyourworkout.Note:
When a program isselected (except for a custom
program), the display willshow the time remaining
in the program instead of the elapsed time. The
display will change from one number to the other
every few seconds.
The Calories/Pulse
display--This display
willshow the approxi-
mate number of calories
you have burned.The
displaywillalso show
t-1
c;-3
your heart rate when you use the handgrip pulse
sensor or the optionalchest pulse sensor.
The Carbs/Inciine dis-
play--This display will
show the approximate
number of grams of
carbsyou have burned
and the inclinelevel of
the treadmill. Note: Each time the inclinechanges,
the displaywillshow the inclinesetting.
The Speed/Pace dis-
play--This display will
show the speed ofthe
walkingbelt and your
pace (pace is measured
in minutes per mile).The
display willchange from one number to the other
every few seconds.
B
Note: The console can display speed and dis-
tance in either miles or kilometers.To change the
unit of measurement, see THE USER'S MODE on
page 18. Note: For simplicity, all instructions in
this section refer to miles.
To see the total number
of miles that the walking
belt has moved since the
last reset, press the
Odometer button; the total
number of miles will ap-
u mm
mm •
NO nunmm
pear inthe matrix.To reset this number,hold
down the Odometer button for a few seconds.
The number will appear in the display for a few
seconds.
Measure your heart rate if desired.
Note: If you use
the handgrlp
pulse sensor
and the op-
tional chest
pulse sensor at
the same time,
the console will
not display
your heart rate accurately. Before using the
handgrip pulse sensor, remove the clear plas-
tic film from the metal contacts. In addition,
make sure that your hands are clean.
To measure your heart rate, stand on the foot
rails and hold the metal contacts--avoid moving
your hands. When yourpulseisdetected,the
heart symbol beside the Calories/Pulse display
will flash and then your heart rate will be shown.
For the most accurate heart rate reading, con-
tinue to hold the contacts for about 15 sec-
onds.
12
To Next Page
Loading...
