NordicTrack CXT 990 - Assembly Instructions; Assembly Requirements and Preparation; Attaching Front and Rear Stabilizers

5
M8 Split
Washer (58)–4
M10 Split
Washer (22)–11
M10 Washer
(63)–2
M8 Washer
(33)–4
M8 x 19mm
Screw (30)–4
M10 x 25mm
Screw (109)–3
M10 x 43mm Screw (65)–4 M10 x 56mm Screw (60)–4 M10 x 36mm Carriage Bolt (61)–2
ASSEMBLY
Assembly requires two people. Place all parts of the elliptical crosstrainer in a cleared area and remove the
packing materials. Do not dispose of the packing materials until assembly is completed. In addition to the two
included allen wrenches, assembly requires a phillips screwdriver , an adjustable
spanner , a rubber mallet , and pliers .
As you assemble the elliptical crosstrainer, use the drawings below to identify the small parts used in assembly.
The number in parenthesis below each drawing refers to the key number of the part, from the PART LIST on
page 25. The second number refers to the quantity used in assembly. Note: Some small parts may have been
pre-attached for shipping. If a part is not in the parts bag, check to see if it has been pre-assembled.
2. Attach the Front Stabiliser (90) to the Frame (1) with
the four M10 x 43mm Screws (65) and four M10 Split
Washers (22). Make sure that the Front Stabiliser is
turned so the Stabiliser Wheels (45) are not touch-
ing the floor.
65
65
90
45
22
22
1
2
1. Identify the Rear Stabiliser (59), which has Levelling
Feet (14) threaded into it. Attach the Rear Stabiliser to
the Frame (1) with the four M10 x 56mm Screws (60)
and four M10 Split Washers (22).
22
1
60
22
59
14
1
60