10
9. IMPORTANT: If the elliptical exerciser has
been exposed to cold temperatures, allow it
to warm to room temperature before plug-
g
ing in the Power Cord (55). If you do not do
this, you may damage the console displays
o
r other electronic components.
Plug the Power Cord (55) into the power socket
at the rear of the elliptical exerciser (see HOW
TO PLUG IN THE POWER CORD on page 11).
Note: The Ramp (not shown) will calibrate
automatically when the elliptical exerciser is
plugged in for the first time.
9
55
10. Make sure that all parts of the elliptical exerciser are properly tightened. Note: Some hardware may be
left over after assembly is completed. To protect the floor or carpet from damage, place a mat under the
elliptical exerciser.
To Next Page
Loading...
Need help?
General
