28
MAINTENANCE
Regular maintenance is important for optimal
performance and to reduce wear. Inspect and properly
tighten all parts each time the exercise bike is used.
Replace any worn parts immediately.
To clean the exercise bike, use a damp cloth and a
small amount of mild soap. IMPORTANT: To avoid
damage to the console, keep liquids away from
the console and keep the console out of direct
sunlight.
CONSOLE TROUBLESHOOTING
If the console does not turn on, make sure that the
power adapter is fully plugged in.
If you are having problems connecting the console
to a wireless network or if you are having problems
with your iFit account or iFit workouts, go to
support.iFit.com.
If a replacement power adapter is needed, call the
telephone number on the cover of this manual.
IMPORTANT: To avoid damaging the console, use
only a manufacturer-supplied regulated power
adapter.
If the console does not boot
up properly, or if the con-
sole freezes and does not
respond, reset the console
to the factory default set-
tings. IMPORTANT: Doing
this will erase all custom settings you have made
to the console. Resetting the console requires two
people. First, unplug the power adapter. Next, locate
the small reset opening (A) on the side or on the back
of the console. Using a bent paper clip, press and hold
the reset button inside the opening, and have a second
person plug in the power adapter. Continue holding the
reset button until the console turns on. When the reset
operation is complete, the console will turn off and then
turn back on. If it does not, unplug and then plug in the
power adapter. Once the console turns on, check for
fi rmware updates (see HOW TO CHANGE CONSOLE
SETTINGS on page 24). Note: It may take a few
minutes for the console to be ready for use.
HOW TO ADJUST THE REED SWITCH
If the console does not display correct feedback, the
reed switch should be adjusted. To adjust the reed
switch, first unplug the power adapter.
See EXPLODED DRAWING A on page 34. Using
a standard screwdriver, gently release the tabs on the
Top Shield (44), and remove the Top Shield.
Next, identify the Access Cover (40). Remove the
M4 x 16mm Screw (77) from the Access Cover, and
then remove the Access Cover.
Next, locate the Reed Switch (46). Turn the Left Crank
Arm (24) until a Pulley Magnet (30) is aligned with
the Reed Switch. Then, slightly loosen the indicated
M4 x 16mm Screw (77), slide the Reed Switch slightly
closer to or away from the Pulley Magnet, and then
retighten the Screw.
Plug in the power adapter, and turn the Left Crank
Arm (24) for a moment. Repeat these actions until the
console displays correct feedback.
When the reed switch is correctly adjusted, unplug
the power adapter and reattach the parts that you
removed. Then, plug in the power adapter.
A
24
30
77
46
MAINTENANCE AND TROUBLESHOOTING
To Next Page
Loading...
Need help?
General
