What to do if my NordicTrack NTXC8018.3 console does not function properly?
To address a console that isn't functioning correctly on your NordicTrack Fitness Equipment, ensure both ends of the console wire are securely plugged in. If the console's display is dim or the console is still not working, replace the batteries.
Why is there no resistance on my NordicTrack Fitness Equipment flywheel?
If the flywheel and/or the resistance strap on your NordicTrack Fitness Equipment offers no resistance, first check the routing of the resistance strap. Also, ensure the flywheel is tight by removing the U-bolt cover and evenly tightening the two M6 nuts on the right side of the flywheel.
How to untangle arm cords on NordicTrack NTXC8018.3 Fitness Equipment?
To fix tangled arm cords on your NordicTrack Fitness Equipment: 1. Wrap cord A counterclockwise around the Pulley until it's fully wound. 2. Pass the end of cord A from left to right through the right Small Pulley and pull to wrap cord B around the Pulley. 3. Feed the end of cord B from right to left through the left Small Pulley and pull until it aligns with the end of cord A. 4. Work the Arm Cord back and forth until evenly wrapped around the Pulley. To reattach handgrips, thread the Arm Cord into the small hole, add an M6 Washer, and tie a figure-eight knot.
Why is my NordicTrack NTXC8018.3 Fitness Equipment arm cord assembly making noise?
If the arm cord assembly of your NordicTrack Fitness Equipment makes noise or the resistance knob loosens, check the order and presence of parts in the pulley assembly. The correct order from the Pulley to the Resistance Knob should be: M10 Washer, Thrust Washer, M10 Washer, and Spring. You can also roughen the leather resistance pad with 100-grit sandpaper and lightly oil it with household oil. Additionally, oil the M10 Washers and the Thrust Washer if needed.
What to do if the skis slip on NordicTrack NTXC8018.3 Fitness Equipment?
If the skis on your NordicTrack Fitness Equipment are slipping, start by wiping off any excess oil. Then, clean the bottoms of the skis with a dry cloth and a small amount of mineral spirits or paint thinner. Finally, make sure that the flywheel is tight by removing the U-bolt cover and evenly tightening the two M6 nuts on the right side of the flywheel.
Instructions on increasing or decreasing ski resistance using the clamp.
Instructions on adjusting arm cord resistance via a knob.
Checks for console wire connections and battery replacement.
Procedure to detach, unwind, and reattach arm cords.
Checks for pulley assembly parts and resistance pad conditioning.
Checking resistance strap routing and flywheel tightness.
Wiping excess oil, cleaning ski bottoms, and checking flywheel tightness.
General| Brand | NordicTrack |
|---|---|
| Model | NTXC8018.3 |
| Category | Fitness Equipment |
| Language | English |
To Next Page