NordicTrack NTL14117.1 - Page 13

13
8. Attach the two Handrails (74) to the Right and
Left Uprights (84, 91) with two 5/16" x 2" Screws
(2) and two 5/16" Star Washers (8); do not
fully tighten the Screws yet. Be careful not to
pinch the Upright Wire (83) on the right side.
Position the Upright Wire in the notch (F) as
shown.
Then, remove and discard the two indicated
screws (G).
G
G
F
84
83
74
74
8
8
9. Set the console assembly (H) face down on
a soft surface to avoid scratching the console
assembly.
Remove and discard the four indicated screws
(I). Then, remove the Pulse Crossbar (80).
Next, identify the Left and Right Trays (94, 101).
Attach the Trays to the console assembly (H)
with eight #8 x 3/4" Screws (11). Do not over-
tighten the Screws.
H
80
I
9
I
8
2
2
I
91
11
101
94
11
11