NordicTrack RW900 - Page 10

10
77
75, 76
8
78
107
92, 93
107
8
8. Note: For clarity, the console is not shown in
this step.
Orient the Right and Left Neck Shields (77, 78)
as shown. Position the Wires (92, 93) inside
of the Left Neck Shield as you press the Neck
Shields together around the Neck (8).
Avoid pinching the wires. Press the Neck
Shields (77, 78) onto the Right and Left Shields
(75, 76).
Then, attach the Neck Shields (77, 78) to the
Neck (8) with two M4 x 16mm Screws (107).
Avoid pinching
the wires
9
9. Orient the Seat (36) as indicated by the sticker,
and slide it into the Rail (2).
36
2
10
10. Orient the Rear Rail Bumper (38) as shown, and
press it into the Rail (2).
Next, attach the Rail End Cover (74) to the
Right and Left Rail Shields (89, 90) with two
M4 x 16mm Screws (107).
Then, attach the Rail End Cover (74) and the
Rear Rail Bumper (38) to the Rail (2) with an
M4 x 16mm Screw (107).
107
38
107
74
5
90
2
89