36
• When installing this Water Heater outdoors, the
“Outdoor Vent Cap (VC-6)” must be used.
• Refer to the instructions provided with Outdoor
Vent Cap for additional detail.
• Disconnect the electrical power and then turn ON
DIP switch #2 if outdoor installation.
Refer to page 56 for the location of the DIP switch
bank and how to change the DIP switch.
Failure to perform this step will result a “73” code
displayed on the Remote Controller and a cease
in operation.
If this occurs, disconnect, then reconnect the
electrical power to the Water Heater to reset the
system.
Here
6.6 Outdoor Installation
Venting the Water Heater
To Next Page
Loading...
