12
Customizable Settings
Stopping Recirculation
Operation
Muting the Remote Controller
The Remote Controller will
emit a sound when any button
is pressed. This sound can be
muted if it is desired.
2. Press and hold the
button until a sound is heard
(approximately 2 seconds).
1. Press and hold the
button for 5 seconds.
4. Change the setting using the
/ buttons.
(Setting completed.)
3. Press the button several
times until the item number
“4” is displayed.
Operation
Operation
• Set the button to ON when
continuing to use the unit as
is. Otherwise, let the unit sit
for approximately 30 seconds.
(Default setting = on)
on: Recirculation on
oF: Recirculation off
Flow Meter Alarm
The flow meter alarm is being
used to indicate when a tub is full.
1. The button is ON.
2. Set the temperature using
the / buttons.
Operation
• Check the current setting
temperature.
• The flow meter setting will be
blinking.
• The maximum hot water
temperature will blink.
• The flow meter alarm cannot
be muted.
• The high temperature warning
tone when setting the unit to
125°F/55°C (131°F) or higher
will not emit a sound when
muted.
4. Turn on hot water.
5. Turn off the hot water when
the alarm sounds to prevent
overfilling.
• The alarm will not sound if it
is set for 990 gal (990 L).
• The level can only be adjusted
while the flow meter setting is
blinking.
• After 10 seconds, the Remote
Controller will again display
the temperature.
• When the tub fills with the
preset volume of water, an
alarm will sound alerting you
to shut off the water.
3.
Press the button, and
adjust with the / buttons.
(Default setting = 990 gal (990 L))
[For gallon]
10 - 60 gal (In 5 gal intervals),
60 - 100 gal (In 10 gal intervals),
990 gal
[For liter]
40 - 240 L (In 20 L intervals),
240 - 380 L (In 40 L intervals),
990 L
[Muted]
No sound after 5 seconds
[Sound]
The sounds after 5 seconds
1. The button is OFF.
(Default setting = Sound)
NOTE
• The hot water filling
temperature is
same as the setting
temperature.
•
Although the
temperature can be
set to 125°F/50°C
or higher, do not set
the temperature to
125°F/50°C or higher
as it can cause severe
burns instantly or
death from scalding.
(e.g. 120°F)
(e.g. on)
To Next Page
Loading...
