8
General Parts
• What is actually displayed depends on how the Water Heater is set.
• Before use, remove the protective sheet from the Remote Controller surface.
Remote Controller (RC-7651M-A)
4
5
6
2
1
NOTE
As shipped from the factory, the
Remote Controller is set to display in
°F and gallons.
To adjust the display to °C and liters,
refer to the Installation Manual.
1. POWER Button / Indicator
For turning the Water Heater ON/OFF.
2. SETTINGS Buon
For setting the flow meter alarm, and other
settings.
3. / Buttons
For setting the hot water temperature, the flow
meter alarm, and other settings.
4. PRIORITY Indicator
When this indicator is displayed, the hot water
temperature can be set.
5. BURNER ON Indicator
When burning, the indicator is displayed.
6. - Temperature Setting (e.g. 110°F)
- Flow Meter Setting (See page 12)
- Error Code
A number will blink if a failure occurs.
(See page 19)
3
To Next Page
Loading...
