4. Open the power switch, the ice maker works. Water sprays from the small
nozzles, find which water sector is not sprayed well. If the reason is the
slideway break the water sector, just adjust the position of slideway to have all
the water sectors flee forward to the ice mold. If the water sectors are free, but
some sector is not sprayed well, using a new teeth-brush clean the gap of the
nozzle several times. The water sector will be OK.
5. This kind of cleaning method can't change the cubes quality (only the ice
cube's shape), you can do another cleaning method. Remove the slideway
from the water bin.
6. Find the sprinkler arm and raise it. Disconnect it from any water tube.
21
To Next Page
Loading...
