NORPOLE NPCIM160H - User Manual

Questions and Answers

M
Michael MillerAug 8, 2025
What to do if my NORPOLE NPCIM160H Ice Maker shows 'E04' error?
- T
  Tina BrownAug 8, 2025
  If the NORPOLE Ice Maker displays an 'E04' error code, it indicates a high temperature issue. Ensure the unit is in an environment with an ambient temperature between 41-104°F (5-40°C). Also, clean the condenser and ensure nothing is blocking airflow. Finally, check that the fan is running and is free from obstructions.
R
ronaldhintonAug 13, 2025
Why is my NORPOLE NPCIM160H Ice Maker ice making process too slow?
- M
  Matthew Robertson IIIAug 13, 2025
  If your NORPOLE Ice Maker is producing ice too slowly, several factors could be at play. First, clean or replace the condenser and air filter if they are dirty. Ensure the unit is in an environment with an ambient temperature between 41-104°F (5-40°C). Also, make sure there is adequate space around the unit for proper ventilation. Finally, verify that the water temperature is between 41-95°F (5-35°C).
C
cchavezAug 17, 2025
What to do if the indicator is ‘Off’ on my NORPOLE Ice Maker?
- T
  thompsonhannahAug 17, 2025
  If the indicator light on your NORPOLE Ice Maker is off, first ensure that the power switch is turned on. Next, verify that the plug is securely connected to a working outlet.
A
ashleygarciaAug 23, 2025
Why is my NORPOLE NPCIM160H Ice Maker not defrosting?
- O
  Omar GarciaAug 23, 2025
  If the NORPOLE Ice Maker is not defrosting properly, make sure the unit is installed somewhere with an ambient temperature of 41-104°F (5-40°C). Check the defrost valve and correct any issues if found. Also, check the ice thickness setting.
W
William HillAug 28, 2025
What does 'E06' error mean on my NORPOLE Ice Maker?
- J
  Jose LewisAug 28, 2025
  If the NORPOLE Ice Maker displays an 'E06' high pressure error code, check and connect the wires on the high pressure switch.
T
Tyler Bell IVSep 1, 2025
Why are the ice cubes from my NORPOLE Ice Maker too thin?
- M
  Michael SmithSep 2, 2025
  If your NORPOLE Ice Maker is making ice cubes with poor transparency, or the ice cubes are too thin or incomplete, check the ice thickness setting. Verify that the water supply pressure is 1.3 Bar to 5.5 Bar. Ensure the water temperature is between 41-95°F (5-35°C). Check the water inlet valve and correct any issues. Check all water connections and tighten as needed. Replace the water inlet filter if it hasn't been replaced for a long time.