NORPOLE NPCIM500M - Display Error Codes; Error Code Reference

DISPLAY ERROR CODES
If the display shows any of these codes, check the unit before calling for customer service.
CODE
CAUSE
MODE
E01
Water Curtain or Ice Full Switch Fault
Sleep mode. Unit will recover
after water curtain is reset.
E03
Ice Harvest Overtime
Sleep Mode
E04
High Temperature Fault
Sleep Mode
E05
Water Shortage Fault
Sleep Mode. Unit will retry every
30 minutes.
E06
Over-Pressure Fault
Sleep Mode
E07
Condenser Temperature Sensor Open
Circuit Fault
Keep Working
E08
Condenser Temperature Sensor Short
Circuit Fault
Keep Working
E09
Water Temperature Sensor Open Circuit
Fault
Keep Working
E10
Water Temperature Sensor Short Circuit
Fault
Keep Working
E13
Water Level Control Fault
Sleep Mode
15