Need help?Do you have a question about the Nortek Control 2GIG GC2e and is the answer not in the manual?
Guide to accessing the Z-Wave toolbox through the services menu on the Home Screen.
Procedure for adding new Z-Wave devices to the system via the Z-Wave toolbox.
Steps to remove Z-Wave devices from the network using the Z-Wave toolbox.
Instructions on how to rename Z-Wave devices within the system interface.
Details on executing basic commands for Z-Wave devices via the panel interface.
Handling and resolving failures during the Z-Wave device inclusion process.
Addressing issues where Z-Wave devices lack necessary node information.
Procedure for learning the panel as a secondary controller in an existing network.
Resolving security inclusion failures when adding the panel to other Z-Wave networks.
Steps to initiate a network check to verify device functionality and routes.
Guide to rediscovering the Z-Wave network to ensure proper device communication.
How to display a comprehensive list of all devices installed in the Z-Wave network.
Procedure to completely reset the Z-Wave controller and its network configuration.
Instructions for adding or managing user access codes for Z-Wave door locks.
Details on supported Z-Wave command classes, security levels, and group identifiers.
General| Brand | Nortek Control |
|---|---|
| Model | 2GIG GC2e |
| Category | Control Panel |
| Language | English |
To Next Page