1
Part names
and their functions
IN
DOOR UNIT
CAUTI
ON
OPERATION INSTRUCTIONS
25će)
Ś If the supply cord is damaged, it must be replaced by qualified person avoid a hazard.
ś Theapplianceshallbeinstalledinaccordancewithnationalwiringregulations.
Ŝ An all-pole disconnection switch having a contact separation of at least 3mmLQ in all poles should be connected in fixed wiring.
NOTE:
16
Air outlet selection switch
This setting blows air from
upper outlet only.
噝
This setting automatically
decides a blow pattern
depending on mode and
conditions.
噝
The unit is shipped from the
factory with this setting.
This setting is recommended.
1. Titanium Apatite Photocatalytic
Air-Purifying Filter:
16.Air outlet selection switch
17.Room temperature sensor:
ƽ It senses the air temperature around the unit.
15.Signal receiver:
ƽ It receives signals from the remote controller.
ƽ
When the unit receives a signal, you will hear
a short beep.
ƽ Settings changed.....beep
2. Air outlet
3.
Display
4. Front panel
5. Louvers (vertical blades)
ƽ
The louvers are inside of the air outlet.
ƽ These filters are attached to the inside
of the air ILOWHUIUDPH.
Air inlet
Air filterIUDPH
Flap (horizontal blade)
Cool mode LQGLFDWRU
Heat mode LQGLFDWRU
Dry mode LQGLFDWRU
Run 212))LQGLFDWRU
LED display
Indoor Unit ON/OFF switch:
Push this switch once to start operation.
Push again to stop it.
The operation mode refers to the following table.
ƽ This switch is useful when the remote controller
is missing.
Model Mode
Temperature
setting
Air flow rate
AUTO
AUTO
COOL
AUTO
COOLING
ONLY
HEAT
PUMP
Opening the Front Panel
Indoor unit
wiring terminal
N(1) 2 3
BU BK
BN
YELLOW/
GREEN
3
9
12
10
14 15
13
11
12
5
6
2
4
7
8
Before opening the front panel, be sure to
WXUQXQLWRIIDQGGLVFRQQHFWSRZHU.
Do not touch the metal parts on the inside of
the indoor unit, as it may result in injury.
17
噝
噝
25će)
To Next Page
Loading...
