6
How to use the remote control to operate the unit
OPERATION INSTRUCTIONS
ȝ
Ɣ
Ɣ
Ɣ
Ɣ
Ɣ
1.Remove the battery cover plate from the rear of the remote controller.
(As shown in the figure)
2.Take out the old batteries.
3.Insert two new AAA1.5V dry batteries, check polarity (+ and - poles).
4. Reinstall the battery cover plate.
Notes:
When replacing the batteries, do not use old or different types of batteries,
otherwise, it may cause malfunction.
If the remote controller will not be used for a long time, please
remove batteries to prevent batteries from leaking.
Keep remote control within receiving range.
It should be kept 1m(3 ft)
away from the TV set or stereo .
If remote controller will not operate after fresh batteries have been installed,
try removing batteries, wait 30 seconds and reinstall.
Sketch map for
replacing batteries
Replacement of Batteries
and " - " buttons simultaneously to switch between
°C
°F
18
Switch from Fahrenheit to Centigrade:
While the unit is turned off, press "MODE"
Press “TEMP” and “CLOCK” simultaneously in COOL mode to start energy-saving function:
The remote controller displays “SE”. Repeat the operation to quit the function.
19
Energy Saving Function
Press “TEMP” and “CLOCK” simultaneously in HEAT mode to start
The unit lights for 4 seconds when energizing for the first time (3 seconds for future operation).
8°C
Heating Function
The remote controller displays “ ” and a selected temperature of “ 8°C (46°F) ”.
(46 ). Repeat the operation to quit the function.
21
Back-lighting Function
20
8°C (46°F)
Heating Function
°F
and
To Next Page
Loading...
