DC Inverter U-match Series Floor Ceiling Type Unit
3.2 Installation Location Selection
ķ. Check the support structure to verify that it has sufficient load-
carrying capacity to support the
weight of the unit and it can be securely mounted.
ĸ. Do not install where there is a danger of combustible gas leakage.
Ĺ. Do not install the unit near heat source, steam, or flammable gas.
ĺ. Children must not operate the unit.
Decide the installation location with the customer as follows:
3.2.1 Indoor Unit
(1). Check the support structure to verify that it has sufficient load-carrying
capacity to support the weight of the unit.
(2). The air inlet and outlet of the unit should never be blocked so that the
airflow can reach every corner of the room.
(3). Leave service space around the unit as required in Fig. 3.1.
ƹFloor type
ƹCeiling type
Fig. 3.1
(4). Install the unit where the drain pipe can be easily installed.
(5). The more space that is open above the unit, the easier it will be to service.
To Next Page
Loading...
