Nortek GHH09(2.6)LUK4DH - Page 15

21
Malfunction Check items Solution
11
SLEEP button
TEMP button
7
8
Introduction for buttons on remote controller
Under COOL, HEAT or DRY mode, press this button to start up sleep function.
" " icon is displayed on remote controller. Press this button again to cancel sleep
function and " " icon will disappear.
By pressing this button, you can see indoor set temperature, indoor ambient temp-
erature or outdoor ambient temperature on indoor unit’s display. as shown below:
no display
on indoor unit displays set temperature.
displays indoor ambient temperature.
displays outdoor ambient temperature.
Note:
Ɣ
Ɣ
Outdoor temperature display is not available for some models. These models will
display the indoor set temperature when outdoor temperature is selected.
TURBO button
5
Under COOL or HEAT mode, press this button to select quick COOL or
HEAT mode. " " icon will display on remote controller. Press this button again
to exit turbo function and " " icon will disappear.
6
auto mode)
Ɣ7RVHW7,0(5217,0(52))RU&/O&.SUHVVŸRUEXWWRQWRDGMXVWWLPH
5HIHUWR&/2&.7,0(5217,0(5O))EXWWRQV
3UHVVŸRUEXWWRQRQFHLQFUHDVHRUGHFUHDVHVHWWHPSHUDWXUH GHJUHH&RU)
+ROGLQJŸRUEXWWRQPRUHWKDQVHFRQGVVHWWHPSHUDWXUHRQUHPRWH
controller will change quickly. On releasing button after setting is finished,
on indoor unit will change accordingly. (Temperature can’t
temperature indicator
EHDGMXVWHGXQGHU