Nortek GHH09(2.6)LUK4DH - Unit Operation and Emergency Procedures; Basic Operation Guide; Emergency Operation Method

15
1.
After turning on the power, press "ON/OFF" button on remote controller to
turn on the air conditioner.
2.
Press "MODE" button to select your required mode: AUTO, COOL, DRY, FAN,
HEAT.
3.
3UHVVŸRUEXWWRQWRVHW\RXUUHTXLUHGWHPSHUDWXUH7emperature can’t
be adjusted under auto mode).
4.
Press "FAN" button to set your required fan speed: auto, low, medium and high
speed.
5.
Press "SWING" button to select fan blowing angle.
Operation guide
Ÿ
Replacement of batteries in remote controller
1. Press the back side of remote controller marked
the cover of battery box along the arrow as indicated.
5HSODFHWZR$$A 1.5V) dry batteries, and
make sure the position of "+" and "-" polar
poles are aligned correctly.
3. Reinstall the cover of battery box.
signal sender battery
Cover of battery box
remove
reinstall
Ɣ'XULQJRSHUDWLRQSRLQWWKHUHPRWHFRQWUROVLJQDOVHQGHUDWWKHUHFHLYLQJ
window on indoor unit.
Ɣ The distance between signal sender and receiving window should be no
more than 8m（25 ft）, and there should be no obstacles in the path.
Florescent lamp, wireless telephone or other devices may interfere with
the remote signal. If this is the case, move the remote closer to the air
conditioner.
Ɣ:KHQUHSODFLQJEDWWHULHVXVHWKHVDPHW\SHRIQHZEDWWHULHV
Ɣ:KHQ\RXGRQ¶WXVHUHPRWHFRQWUROOHUIRUDORQJWLPHSOHDVHWDNHRXWWKH
batteries.
Ɣ,IWKHGLVSOD\RQUHPRWHFRQWUROOHULVIX]]\RUWKHUH’s no display, please
replace batteries.
NOTICE
Ɣ