Nortek GHH09(2.6)LUK4DH - Installation of Indoor Unit

26
Installation of indoor unit
Step one: choosing installation location
Step two: install wall-mounting frame
rm before installing.
1. Hang the wall-mounting frame on the wall; make sure it is level. Mark the screw
locations on the wall.
Drill holes in the wall for screws. Insert plastic expansion or anchor in the hole.
3. Attach the wall-mounting frame on the wall with tapping screws (ST4.2X25TA) and
1. Select the location for the outlet pipe and make an opening in the wall. The
position of piping hole should be a little lower than the wall-mounted frame,
shown as below.
Step three: open piping hole
2SHQDSLSLQJKROHZLWKWKHGLDPHWHURIĭLQDWWKHVHOHFWHG
position. In order to drain smoothly, slope the piping hole on the wall slightly
GRZQZDUGWRWKHRXWGRRUVLGHZLWKWKHJUDGLHQWRI
、12K: 18K:
24K:
Left
Wall
ĭPPLQ
ĭPPLQ
Right
Mark in the middle of it
Level
Rear piping hole
Wall
Space
to the
wall
Space
to the
wall
Rear piping hole
Left
Wall
ĭPP（LQ）
ĭPP（LQ）
ĭPP（LQ）
Right
Mark in the middle of it
Level
Rear piping hole
Wall
Space
to the
wall
at least
PP（LQ）
at least
PP（LQ）
at least
PP（LQ）
at least
PP（LQ）
at least
PP（LQ）
Space
to the
wall
at least
PP(LQ)
ĭPPLQ
Rear piping hole
Left
Wall
Right
Mark in the middle of it
Level
Rear piping hole
Wall
Space
to the
wall
Space
to the
wall
Rear piping hole