DMS-100 Family XPM International Translations Reference Manual XPM12 and up
iii
Contents
About this document vii
When to use this document vii
How to check the version and issue of this document vii
References in this document vii
What precautionary messages mean viii
How commands, parameters, and responses are represented ix
Input prompt (>) ix
Commands and fixed parameters ix
Variables ix
Responses ix
XPM International Translations Introduction 1-1
Introduction to data tables 2-1
Tuple properties 2-1
Using the table editor 2-2
Procedures for datafilling any system 2-3
Input prompts and prompting mode 2-3
Nonprompt mode 2-4
Activating changes to tables 2-4
Table editor commands 2-5
Remote Switching Center-SONET International 3-1
Understanding RSC-S International translations 3-1
Differences between RSC and RSC-S 3-1
Software functionality 3-1
Revised system architecture 3-2
Packaging 3-2
Cabinetized remote switching center (CRSC) cabinet 3-3
CRSC extension (CEXT) cabinet 3-4
Cabinetized line modules (CLCE) 3-5
Cabinetized power distribution center (CPDC) cabinet 3-5
Cabinetized miscellaneous equipment (CMIS) cabinet 3-5
Cabinetized miscellaneous spares storage (CMISS) cabinet 3-5
RSC-S services 3-5
RSC-S configurations 3-6
Preparing to datafill for RSC_S_International 3-9
PCL—New Software Delivery Vehicle 3-9
Collecting end-user data 3-9
Configurations 3-10
To Next Page
Loading...
Need help?
General
