Step 7 – Horizontal Latch to Beam
• Align horizontal latch to beam using (2) bolts and (2) nuts.
• Torque to 71 ft.-lb.
• Ensure that the Outrigger leg is in the DOWN position.
• Using the handle on the beam, lower beam to the tow bar. Pull
horizontal lock latch rod outwards to allow the beam to rest properly on
the tow bar. Push latch rod forward to lock in the horizontal position.
• See page 20 for further instruction.
• Note: If horizontal latch bracket does not latch correctly. Loosen
bolts/nuts and adjust horizontal latch bracket. If further adjustment is
needed, loosen bolts/nuts from Step 6 and adjust pivot mount bracket.
To Next Page
Loading...