EasyManua.ls Logo

NorthFlo PSNF65VS - Pre-Operation Testing; Inspection Before Use; Trial Run Procedure

Default Icon
32 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
10
VIII.
Precautions
1. Attention
A. Set proper temperature in order to get comfortable water temperature; to avoid
overheating;
B. Please don’t stack substances that can block air flow near inlet or outlet area, or the
efficiency of the heater will be reduced or even stopped;
C. Please don’t put hands into outlet of the swimming pool heater, and don’t remove the
screen of the fan at any time;
D. If there are abnormal conditions such as noise, smell, smoke and electrical leakage,
please switch off the machine immediately and contact the local dealer. Don’t try to
repair it yourself;
E. Don’t use or stock combustible gas or liquid such as thinners, paint and fuel to avoid
fire;
F. In order to optimize the heating effect, please install heat preservation insulation on
pipes between swimming pool and the heater. During running period of the
swimming pool heater, please use a recommended cover on the swimming pool;
G. Connecting pipes of the swimming pool and the heater should be ≤10m, or the
heating effect of the heater cannot be ensured;
2. Safety
A. Please keep the main power supply switch far away from the children;
B. When a power cut happens during running, and later the power is restored, the
heater will start up automatically. So please switch off the power supply when there
is a power cut, and reset temp when power is restored;
C. Please switch off the main power supply in lightning and storm weather to prevent
from machine damage that caused by lightning;
D. If the machine is stopped for a long time, please cut off the power supply and drain
water clear of the machine by opening the tap of inlet pipe.
IX.
Maintenance
A In winter season when you don’t swim:
1. Cut off power supply to prevent any heater damage
2. Drain water clear of the heater.
3. Cover the heater body when not in use.
1. “Cut off”
power supply of the heater before cleaning, examination and repairing
2
. Do not touch the electronic components until the LED indication lights on PCB is off/
turn off.
Caution: Danger of electric shock
!!Important:
Unscrew the water nozzle of inlet pipe to
let the water flow out.
When the water in machine freezes in winter
season, the titanium heat exchanger may be
damaged.

Related product manuals