Need help?Do you have a question about the NorthStar NP2 and is the answer not in the manual?
General| Brand | NorthStar |
|---|---|
| Model | NP2 |
| Category | Measuring Instruments |
| Language | English |
Configures output extension for Relay 1 after vehicle departure (0-10 seconds).
Sets a 2-second delay for Relay 1 detection, ignoring initial vehicle presence.
Defines Relay 1 presence duration as 1 hour or permanent.
Sets the pulse duration for Relay 2 to 250mS or 500mS.
Selects Relay 2 function: pulse-on-entry, pulse-on-leaving, presence, or fault.
Front panel rotary switch controls sensitivity levels 0-8.
DIP switches control four frequency bands: Low, Medium Low, Medium High, High.
Initiates a hard reset of the detector via the front panel.
Explains the function of Power, Relay 1, Relay 2, and Fault indicator LEDs.
Lists pre-configured settings for frequency, sensitivity, pulse length, and relay modes.
Automatically boosts sensitivity during detection, excluding setting 9.
To Next Page
