Nouvag Vacuson 40 - User Manual

Questions and Answers

A
alexander95Aug 7, 2025
Why is the suction pump on my Nouvag Vacuson 40 not functioning?
- C
  cmorrisAug 7, 2025
  If the suction pump on your Nouvag Medical Equipment isn't working, consider these potential causes: 1. Ensure the vacuum pump is switched on by connecting the On/Off-AIR-Pedal at the rear of the device. 2. Check all seals and tubes to make sure the vacuum system is airtight and that the jar lid is properly closed. 3. Ensure the air inlet port at the rear of the device is closed with its cap. 4. Verify that all tubes are connected correctly. 5. If the jar is full, replace it with a fresh, empty one, as the overflow protection may have locked down. 6. Ensure you have read the instruction manual carefully.
L
Lauren BarreraAug 12, 2025
What to do if the pedal of my Nouvag Medical Equipment is not functioning?
- O
  operezAug 13, 2025
  If the pedal isn't working with your Nouvag Medical Equipment, try these steps: * Make sure the On/Off-AIR-Pedal is correctly connected to the device at the rear. * Confirm that the control unit is switched on by setting the main switch “I/O” to “I”. * Review the instruction manual carefully to ensure correct operation.
K
Kayla ParkAug 17, 2025
What to do if my Nouvag Water Pump device is not operational?
- L
  lawrence52Aug 17, 2025
  If your Nouvag Water Pump device is not operational, there might be several reasons. First, ensure the pump is switched on by setting the main switch “I/O” to “I”. Check the power cord connection to the electricity supply. Verify that you're using the correct voltage for your pump. Finally, inspect the fuses and replace them if they are defective.
J
Joseph SmithAug 22, 2025
Why is my Nouvag Water Pump suction pump not functioning?
- C
  Claudia VegaAug 22, 2025
  If the suction pump of your Nouvag Water Pump isn't functioning, consider these potential causes: * The On/Off-AIR-Pedal might not be connected; ensure it's connected to the device at the rear. * The vacuum system may not be airtight; check all seals and tubes, and ensure the jar lid is properly closed. * The air inlet port at the rear of the device might be open; close it with its cap. * The tubes could be connected incorrectly; ensure they are properly connected. * The jar might be full, causing the overflow protection to lock down; replace the full jar with a fresh, empty one.
A
Anthony EdwardsAug 27, 2025
What to do if my Nouvag Water Pump pedal is not functioning?
- L
  lwardAug 27, 2025
  If the pedal of your Nouvag Water Pump is not functioning, check if the On/Off-AIR-Pedal is connected to the device at the rear. Also, verify that the control unit is switched on by setting the main switch “I/O” to “I”.
J
Jacob RubioSep 1, 2025
What to do if my Nouvag Water Pump suction pump is not working properly?
- T
  tyoungSep 2, 2025
  If the suction pump of your Nouvag Water Pump is not working properly, check that the vacuum controller is opened wide enough by turning it clockwise. Also, the vacuum system may not be airtight, so check all seals and tubes and make sure the jar lid is properly closed.