Nova Neptune Max - Page 27

27
137-01-2305
128-0621-003
6.4.2 Warning messages
The warning message table is not editable information, *Try to report the fault with Error code.
Error code
Error description
Error code
Error description
E-0
Unexpected Fault
E-6
Low Voltage
E-1
SRM not Rotate
E-7
PFC_Fault
E-2
RPS_State_Error_0
E-8
Overheat
E-3
RPS_State_Error_1
E-9
EEPROM_Data_Fault
E-4
Hardware Fault
E-10
EEPROM_Work_Fault
E-5
Unexpected Trap
6.4.3 Factory reset
Stop the motor first, press [Down & Hold] speed knob +[ON] for 3second. The HMI is reset to the factory settings, the
machine will reboot again.
6.4.4 USB mode for HMI firmware upgrade
Stop the motor first, press [Down & Hold] speed knob +[FUNC] for 3second. The HMI enters the USB mode for firmware
upgrade.
Download HMI USB/DFU update software and firmware from the website: www. teknatool.com, follow the instructions
to upgrade HMI firmware.