Nova TITAN User Manual

HOW TO SERVICE NOVA CHUCKS


SAFETY WARNING
Safety glasses must be worn when dealing with snap rings on the
chucks. Snap rings can for fly off in any direction. Use caution and
wear safety glasses.
 Note: Remove jaws or any other accessories attached on the chucks
before disassembling the chucks. Wipe/blow off visible dust from the
chucks before disassembly.
Preparation:
Before starting the disassembly, lay a disposable thick towel or cloth on top of the
working area as the disassembly process can get messy. The towel will protect the
chuck body during this process.
This guide outlines the disassembly, cleaning and reassembly for:
 Precision Midi
 G3
 SuperNOVA2
 Titan
p.1

Nova TITAN Specifications

General

Category	Outdoor Furnishing
Frame Material	Aluminum
Cushion Material	Polyester
Material	Rattan
Table Shape	Rectangle

Summary

How to Service Nova Chucks

Safety Warnings for Chuck Servicing

Crucial safety precautions for handling chucks, emphasizing eye protection and caution with snap rings.

Preparation for Chuck Disassembly

Steps to prepare the workspace and chuck, including laying a towel and noting initial cleaning.

SuperNova2 Chuck Disassembly

Step 3: Detach the Backing Plate

Remove the backing plate using screwdrivers or a mallet, acknowledging potential difficulty due to lubricants.

SuperNova2 Chuck Cleaning Procedure

Step 2: Apply Degreaser for Grime

Apply a degreaser or rust remover to parts with built-up grime and allow it to soak for at least two hours.

Step 3: Scrubbing Stubborn Grime

Use a wire brush on the scroll ring and jaw slides, especially in slits, to remove rust and difficult grime.

SuperNova2 Chuck Reassembly Guide

Step 1: Lubricate Moving Surfaces

Apply ample lubricant to all surfaces that will contact other parts during reassembly.

Step 2: Reinsert Jaw Slides Correctly

Step 3: Align Jaw Slides for Square

Step 4: Slide and Seat the Scroll Ring

Step 7: Check Jaw Alignment with Key