Need help?Do you have a question about the NOVAK NESC-1X and is the answer not in the manual?
General| Brand | NOVAK |
|---|---|
| Model | NESC-1X |
| Category | Controller |
| Language | English |
Prevent metal contact with transistor tabs/heat sinks and avoid shorting to chassis or components.
Plug the speed control connector into the receiver throttle channel. No other power supply is needed for receiver/servo.
Install the 30 amp fuse with heat shrink tubing; not using it voids the warranty.
Install 0.1µF capacitors on the motor and a 47µF capacitor on the speed control side.
Adjust neutral pot for motor stop, then speed pot for full throttle voltage/response.
Insulate between heat sinks with double-sided tape to prevent shorts.
Address dead motor/servo with intact fuse, no brakes, overheating, or melted case.
Do not use incorrect connectors, skip fuse, damage heat sinks, or expose to moisture.
To Next Page