This guide provides the basic information needed to set up and use a NovAtel
®
ProPak6.
USER MANUALS
For detailed information on the installation and operation of the NovAtel receiver, download the ProPak6
User Manual (OM-20000148).
For detailed information on the logs and commands used to configure the NovAtel receiver, download the
OEM6 Family Firmware Reference Manual
(OM-20000129).
BOX CONTENTS
The following is provided with the ProPak6 (NovAtel part number):
• ProPak6 receiver with built in Wi-Fi, Bluetooth
®
, USB 2.0 and 4 GB of onboard memory
• 12 VDC power adapter (CLA) with slow blow fuse (01017663)
• Null modem serial cable (01017658)
• DB9 male extension cable (01018520)
• I/O DB9 male interface cable (01018519)
• Mounting bracket and screws (70023096, quantity 2 and 28523058, quantity 4)
Additional Equipment Required
The additional equipment listed below is required for a typical setup (refer to ProPak6 User Manual (OM-
20000148) for further details).
• A standard 12 VDC power outlet or 9-36 VDC power supply capable of at least 14 W
• A Windows computer with a RS-232 DB-9, Ethernet or USB port
• A quality GNSS antenna, such as NovAtel’s 700 or ANT series
• An antenna cable with a TNC male connector at the receiver end
such as NovAtel’s GPS-C016 model
• A cellular antenna and SIM card (model dependant)
If a SPAN
®
GNSS+INS capable ProPak6 was purchased, download the SPAN on
OEM6 Quick Start Guide (GM-14915112). To purchase SPAN firmware, contact
Sales@NovAtel.com to obtain SPAN software functionality for your receiver.
To Next Page
Need help?
General
