How to fix command errors on Novatel OEM615 Receiver?
If a command is not accepted by the Novatel Receiver, verify the spelling and syntax of the command. Ensure that the command is entered correctly.
What to do if Novatel OEM615 has overload and overrun problems?
If your Novatel Receiver is experiencing overload or overrun issues due to CPU or port buffer overload, reduce the amount of logging or increase the baud rate.
What to do if Novatel Receiver temperature is out of range?
If your Novatel Receiver shows an environmental or memory failure because its temperature is out of the acceptable range, move the receiver to within an acceptable temperature range.
How to fix Novatel Receiver communication failure?
To address a communication failure with your Novatel Receiver, check and replace any faulty serial cables and ports.
How to fix Novatel Receiver not properly powered?
If your Novatel Receiver is not properly powered, check and replace a faulty power cable.
What to do if Novatel OEM615 Receiver is not tracking satellites?
If your Novatel Receiver is not tracking satellites, ensure that the receiver has an unobstructed view of the sky from horizon to horizon. Also, check the antenna cable for faults and replace it if necessary.
Why is my Novatel Receiver outputting random data?
If random data is being output by the Novatel Receiver, or binary data is streaming, check the baud rate on both the receiver and in the communication software to ensure they match.
Why is Novatel OEM615 showing overload errors?
If the Novatel Receiver is experiencing overload or overrun problems, which means either the CPU or port buffers are overloaded, reduce the amount of logging or increase the baud rate.
What to do if Novatel Receiver is affected by jamming?
If your Novatel Receiver is experiencing jamming, relocate it away from potential sources of interference.
What to do if Novatel OEM615 Receiver shows temperature failure?
If the Novatel Receiver temperature is out of the acceptable range, or the internal thermometer is not working, move the receiver to an environment within an acceptable temperature range.
General| Type | GNSS Receiver |
|---|---|
| Frequency Bands | L1, L2, L5 |
| Interface | RS-232, USB, Ethernet |
| Power Supply | 3.3 VDC |
| Update Rate | Up to 20 Hz |
| Velocity Accuracy | 0.03 m/s |
| Timing Accuracy | 20 ns |
| Operating Temperature | -40°C to +85°C |
| Time Accuracy | 20 ns |
| Weight | 24 g |
| Signals Tracked | GPS, GLONASS, BeiDou, Galileo, SBAS |
| Power Consumption | 1.2W |
| Protocols | NMEA 0183 |
| Acquisition Time | Cold start: <50 s |
| Voltage | 3.3 VDC |
| Input Voltage | 3.3V to 5.5V DC |
To Next Page
