Ethernet Configuration Chapter 6
OEM6 Family Installation and Operation User Manual Rev 12 87
6.2 Static IP Address Configuration
For a static IP address configuration, unique IP addresses are assigned to both the OEM6 receiver and the
computer. TCP/IP is used for the connection in this simple network. This configuration can also be used in a
bench test environment to confirm Ethernet functionality.
For connections when an OEM6 receiver uses a static IP address configuration, refer to the following:
Figure 39: Cross-Over Ethernet Cable Configuration—OEM628 and OEM638
Figure 39, Cross-Over Ethernet Cable Configuration—OEM628 and OEM638 on page 87
Figure 40, Cross-Over Ethernet Cable Configuration—FlexPak6 on page 88
Antenna Cable
Cross-over
Ethernet Cable
Antenna
OEM6 Board in a
Development Kit
Computer
To Next Page
