Operation OEM6 Cards and Enclosures Chapter 4
OEM6 Family Installation and Operation User Manual Rev 12 80
4.11.9 Pass-Through Logging
The pass-through logging feature enables the GNSS receiver to redirect any ASCII or binary data that is
input at a specified COM port or USB port, to any specified receiver COM or USB port. This capability, in
conjunction with the SEND command, allows the receiver to perform bidirectional communications with other
devices such as a modem, terminal or another receiver.
There are several pass-through logs: PASSCOM1, PASSCOM2, PASSCOM3, PASSXCOM1, PASSXCOM2,
PASSXCOM3, PASSUSB1, PASSUSB2, PASSUSB3, PASSICOMX, PASSNCOM and PASSAUX are
available on OEM6 family receivers for logging through serial ports. Refer to the PASSCOM logs in the OEM6
Family Firmware Reference Manual (OM-20000129) for details.
To Next Page
