Ethernet Configuration Chapter 6
OEM6 Family Installation and Operation User Manual Rev 12 91
6.3 Dynamic IP Address Configuration
For this configuration, a direct connection is made from the OEM6 receiver to a Dynamic Host
Communication Protocol (DHCP) network and into a computer. The DHCP server automatically assigns an
IP addresses to the OEM6 receiver, based on its predetermined available IP addresses. Use this
configuration in a bench test environment to confirm Ethernet functionality.
Figure 41, Dynamic IP Address Configuration through a DHCP Server—OEM628 and OEM638 on page 91
and Figure 42, Dynamic IP Address Configuration through a DHCP Server—FlexPak6 on page 92 show the
connections when an OEM6 receiver uses a dynamic IP address configuration.
Figure 41: Dynamic IP Address Configuration through a DHCP Server—OEM628 and OEM638
Antenna Cable
Ethernet
Antenna
OEM6 Board in a
Development Kit
Computer
Cable
Ethernet
Cable
DHCP Server
To Next Page
