Ethernet Configuration Chapter 6
OEM6 Family Installation and Operation User Manual Rev 12 89
IPCONFIG ETHA STATIC 192.168.74.10 255.255.255.0 192.168.74.1
6. Save the new Ethernet settings by entering:
SAVECONFIG
7. Log the IPCONFIG command and confirm the TCP/IP configuration by entering:
LOG IPCONFIG ONCE
8. Configure your computer with a static IP address.
For a computer using Windows 7, refer to Section 6.2.2, Static IP Address Configuration—Windows 7 on
page 89.
6.2.2 Static IP Address Configuration—Windows 7
Follow these steps to set up a static IP address on a computer:
1. Click Start | Control Panel.
2. Click Network and Sharing Center.
3. Click the Local Area Connection link.
The Local Area Connection Status window appears.
4. Click the Properties button.
The Local Area Connection Properties window appears.
5. Select Internet Protocol Version 4 (TCP/IPv4) and then click the Properties button.
The Internet Protocol Version 4 (TCP/IPv4) Properties window appears.
6. Click the Use the Following IP Address radio button, then enter the IP address, Subnet mask and
Default gateway for the Ethernet port on the computer.
7. Click the OK button.
The Local Area Connection Properties window appears.
8. Click the Close button.
The Local Area Connection Status window appears.
9. Click the Close button.
10. Proceed to Section 6.2.3, Confirming Ethernet Setup on page 90.
The command assigns the following values to the OEM6 receiver:
IP address = 192.168.74.10
Subnet mask = 255.255.255.0
Gateway = 192.168.74.1
These settings are examples only. The settings appropriate to your system may be
different.
Ensure the Ethernet settings used for the computer are compatible with the Ethernet
settings on the OEM6 receiver.
For example, the following settings are compatible with the OEM6 receiver settings used
in Section 6.2.1, Static IP Address Configuration—Receiver on page 88:
IP address = 192.168.74.11
Subnet mask = 255.255.255.0
Gateway = 192.168.74.1
To Next Page
